Image

Parts Charts


 

Basic Frame & Covers

Basic Frame Covers

Reference NumberVilter Part NumberDescription



(a) Use VPN 13152M (Screw, 5/8" X 3-3/4" Hex. Head Cap) for four bolt hole locations at raised face on Water Jacket.

(b) There are different versions of Handhole cover. Handhole cover for 3” sight glass is not available (compressors with serial number starting from 0 thru 13049).

 

* Check your Operator‘s Manual for correct Part Number for your specific compressor model.

 

Crankshaft & Front Bearing Cover

Reference NumberVilter Part NumberDescription

 

* Check your Operator‘s Manual for correct Part Number for your specific compressor model. Splash shield included in crankshaft with bearings.

 

Piston, Connecting Rod & Safety Head

piston, connecting rod and safety head

Reference NumberVilter Part NumberDescription

 

(a) Applicable for compressors with serial number starting from 3638 thru 13490

 

Rear Bearing Cover & Filter Assembly

rear bearing cover and filter assembly

Reference NumberVilter Part NumberDescription

 

* Check your Operator‘s Manual for correct Part Number for your specific compressor model.

 

Cylinder Liner & Capacity Control

cylinder liner and capacity control

Reference NumberVilter Part NumberDescription

 

(a) 410A and 410B- Sold for replacement use only; will not fit present pistons.

(b) 410C and 410D- Not interchangeable with 410A and 410B used on compressor serial numbers below 3638.

(c) 411A and 411B- Present pistons cannot be used with rings kit used for compressor serial numbers below 3638. KT034 contains 410C; KT364 contains 410D/E.

(d) 411C- New piston, used on compressors with serial number starting from 32500 for gas unloading & from 22800 for oil unloading, is not interchangeable with piston (pre 1985 year) used on compressors serial number starting from 19247 thru 22799 for oil unloading and from 3638 thru 19246 & 30000 thru 32499 for gas unloading (requires different frame). New piston has two grooves- top for gas and bottom for oil.

(e) 413 and 413A- Yoke lifting arms not interchangeable.

Vilter-product

450XL MODEL SHOWN

Replacement Parts List 440 & 450XL Series Compressors

 

 

300 and 400 Series VMC Reciprocating Compressors Service Interval Requirements

 

The following service intervals are based on the usage of Vilter Manufacturing Corporation 
Premium Grade refrigeration oil in 300 and 400 Series VMC Compressor units.

300 and 400 Series VMC Reciprocating Compressors Service Interval Requirements

 

 Key:     I       Inspect.
  R     Replace or Service.
  S     Sample.

 


Notes:

  1. The oil should be changed at these intervals, unless oil analysis results exceed the allowable limits. The frequency of changes will depend on the system cleanliness.
  2. Oil analysis should be done at these intervals as a minimum; the frequency of analysis will depend on system cleanliness.
  3. The oil filter on a minimum must be changed at these intervals or annually if not run continuously. However, the oil filter must be changed if the oil filter differential exceeds 25 psi or oil analysis requires it
  4. To prevent possible breakdowns, the compressor should be opened and the condition of the valves, valve seats, liners and connecting rod bearings should be checked and excessively worn parts be replaced. At the same time the crankshaft bearing float should also be checked.